What PCB design and prototyping covers
The printed circuit board is where an electronic product's cost, size, reliability and manufacturability are mostly decided. A board that works on the bench can still fail in production because of a part that is hard to buy, a layout that picks up noise, or a connector that doesn't fit the enclosure.
SD Corpe designs boards together with the firmware and the enclosure. Our hardware engineers know what the firmware needs from the board, and our firmware engineers bring the first prototypes up, so problems are found and fixed in the first revision instead of the third.
What we deliver
- Schematic capture and circuit design. Power supplies, microcontroller and radio circuits, sensor interfaces, motor drivers and protection circuits, designed from your requirements and reviewed before layout starts.
- PCB design and layout. Board stack-up, component placement and routing with attention to power integrity, noise, antenna placement, heat and testability.
- Component selection and sourcing. Parts chosen for availability and lifecycle as well as performance, with approved alternatives for critical components to reduce the risk of shortages.
- 3D modeling and enclosure design. Enclosure and mechanical design in SolidWorks or Fusion 360, checked against the board in 3D before anything is made, with 3D-printed parts for early prototypes.
- Prototype assembly and testing. Prototype boards assembled, brought up and tested with oscilloscopes and logic analyzers, with a list of fixes for the next revision.
- Hardware and software integration. Board, firmware and enclosure tested together as a complete product.
- Manufacturing files. Gerber files, bill of materials, assembly drawings and pick-and-place data that a PCB manufacturer can use directly.
How a hardware project runs
- Requirements. Functions, interfaces, size, power source, operating environment, target cost and any certification the product needs.
- Proof of concept. Critical circuits are tested on development boards or small test boards when there is real technical risk.
- Schematic and review. The full schematic with component choices, reviewed with you and with our firmware team.
- Layout and enclosure. PCB layout and mechanical design developed together, with 3D checks for fit.
- Prototype and test. Boards are fabricated and assembled, then brought up, measured and tested against the requirements.
- Revision and production files. Fixes from testing go into the next revision, followed by the files and test procedures needed for production.
Designing for certification and production
If your product needs certification, such as CE or FCC marking or an industry-specific standard, tell us at the start. It affects component choice, layout, filtering and test plans, and it is much cheaper to design for than to fix afterwards. In the same way, we plan test points and programming connectors so that every unit can be programmed and checked quickly on the production line.
Why work with SD Corpe
We design boards for the products we also program and connect, so our layouts are made to be debugged, updated and built in volume. Since 2022 we have delivered 150+ projects for 50+ clients. Read about the stages of hardware product development, or see our embedded systems and firmware services for the rest of the device. All design files are transferred to you when the project is complete.